Hi Scratchpaws,
Do you want stereo?
How tall are your trees?
Here is an example from my sound journal, of the wind and red alder recorde=
d using a Telinga parabolic dish with Shure WL183 microphones. The source o=
f creaking was located about 30ft up though also resonating down the trunk,=
and the leaf canopy was 40 to 50 feet high.
http://www.rockscallop.org/ear/041212_RedAlder.mp3
If the canopy is fairly low, maybe 20 feet or less, then spaced omnis place=
d on the ground with the tree in-between might work. Depending on the local=
topography, recording from ground level can restrict the horizontal sound =
horizon, so it might reduce some of surrounding sounds you are concerned wi=
th.
The following example might not be the best as the subject, sagebrush, is n=
ot very tall. It was with Shure WL183 around the base of the sage, at groun=
d level, a couple feet apart, aiming upward.
http://www.rockscallop.org/ear/jh-080425-1700_sage-wind.mp3
I have more recent recording of a 15 to 20 foot juniper tree that I will pr=
esent momentarily in a subsequent post. The WL183 has self noise too high f=
or quieter settings, but they work great for some things - like recording t=
he wind.
I have not tried shotgun mics for wind sounds, but that might also work wel=
l - someone else will have to speak to it. Of course in general, the closer=
you get your mics to the actual subject, the more specific the result will=
be.
John Hartog
www.rockscallop.org
--- In "scratchpaws" <> wr=
ote:
>
> I have a Sony PCM D50 Linear PCM Recorder.
>
> I want to record "clean" wind in the top branches of trees with as little=
ambient noise as "reasonably" possible.
>
> The on-board mics pick up too much ambient noise to give me the "specific=
rustle" of wind noise in the leaves at ground level, without the "general =
roar" of wind coming from everywhere around me. I'm thinking the tops of tr=
ees would offer the best of what I'm looking for.
>
> Does anyone have any input as to a good mic configuration for this?
> I assume either a shotgun or a parabolic reflector, however, words of wis=
dom from the gurus would be most appreciated before I go off spending a lot=
of money burning daylight to find a solution.
>
> Thanks
>
|