RE: attenuating HiMD mic input (was draft procedure..)

[Dan Dugan <>]

Gene Dorcas wrote:

>The "low" sensitivity setting works ok but sometimes the when I import to
>Audition the amplitude is very low

In that case you should have been using a higher gain setting... Is 
this with a dish?

>and when I increase the amplitude I think
>I am also amplifying any MD pre noise at the same time so I would be happier
>if I had some variable control over the mic sensitivity.
>
>I wonder if anyone has simply used a variable resistor network (L-pad or
>other) as an attenuator.  My present thinking is that this would give me
>more flexibility. I would appreciate being corrected if my reasoning is
>wrong.

I don't think you can pad with plug-in-power.

-Dan Dugan


________________________________________________________________________
________________________________________________________________________