| Subject: | Re: a preamp survey |
|---|---|
| From: | Klas Strandberg <> |
| Date: | Sun, 15 Feb 2004 23:35:42 +0100 |
ALL: The mail below should NOT have been sent! It is not finished!!
Sorry.
Klas.
Dan Dugan wrote:
>The way to listen to -just- preamp noise is to solder a 200-ohm
>resistor across pins 2 and 3 of an xlr, and plug that in as a "dummy
>mic." You can make valid comparisons of the noise of different
>preamps this way, assuming a method for setting them at the same gain.
>
Hmmmm. 2 * 200 Ohms in series with a condensor from pins 2 and 3 to ground!
Klas.
Telinga Microphones, Botarbo,
S-748 96 Tobo, Sweden.
Phone & fax int + 295 310 01
email:
________________________________________________________________________
________________________________________________________________________
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: a preamp survey, Klas Strandberg |
|---|---|
| Next by Date: | Re: a preamp survey, thorley_tom |
| Previous by Thread: | Re: a preamp survey, Klas Strandberg |
| Next by Thread: | Re: a preamp survey, thorley_tom |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
The University of NSW School of Computer and Engineering takes no responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the naturerecordists mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU