DAN DUGAN
> >I would connect the tip and ring together at the mini-plug end, so
>>the mike will feed both channels.....
KLAS
>If you connect the two channels of a plug in power input, you get half the
>available input impedance, which MAY load the output of the microphone.
>(depends on the mic output impedance)
>Or have I misundertood the issue here?
>
>Plug in power inputs shall not be connected, for mono. Then you also connect
>the two resistors, providing the plug in power. You have to connect the two
>channels with a condensor.
Correct, but I haven't encountered a problem with just strapping them
together. Also the plug-in power current supply will be doubled, but
this XLR adaptor is for connecting a dynamic or pro condensor mike,
and that hasn't come up.
-Dan Dugan
________________________________________________________________________
________________________________________________________________________
|