Thank you.
Yes you are correct I intended the "hot" to start around 2,000
cycles. If you want lower freqs as well than a larger base is needed
as well as changing the signal capacitor to .1 uf. I would like to
find the exact cap values to give an exact low cutoff. I was using a
value based on experience without using the math. If anyone has the
math that would be nice.
rich peet
--- In Rob Danielson <> wrote:
> Hi Rich--
>
> Thanks very much for sharing this with us. You mic is elegant and
> sounds quite good. Some have written that some caps radio shack
> sells include WM-61A's. Dunno. To my ears, your mic sounds a tad
> peaky circa 2300Hz for a WM-61A but then the small pzm surface
might
> be part of this. Noise and output seem comparable. Another
addition
> for the cheap but decent recommendation gear list we've written
> about. The strainer as windscreen substructure is definitely a
keeper.
> Rob Danielson
________________________________________________________________________
________________________________________________________________________
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
|