I have used the TS-ADC16 with the TS-7800, with 16-bit access.
I had jumper 3 ON the TS-ADC16, and I set the TS special ISA pinout enable bit
on the TS-7800. See section 5.2.4 in the TS-7800 manual.
--- In "Mike" <> wrote:
>
> Hi All,
> I was wondering if anyone else had come across this problem. When reading
> from the FIFO on the ADC16 there are two choices. The first is to read from
> a single 16 bit location, address 0x0A. The documentation for the board
> itself uses this method. However, one can also read from the two 8 bit
> registers located at 0x1A and 0x1B. The issue I'm having is that the values
> read from them appear to be significantly different. I'm only able to get
> accurate results off of the two 8 bit registers, which is frustrating because
> it is slowing my performance by a decent chunk. Any ideas? Is there perhaps
> some initialization that I have to do, I'm running it on top of a TS-7800
> board. Thanks for the help,
>
> Mike
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|