Hi All,
I was wondering if anyone else had come across this problem. When reading from
the FIFO on the ADC16 there are two choices. The first is to read from a
single 16 bit location, address 0x0A. The documentation for the board itself
uses this method. However, one can also read from the two 8 bit registers
located at 0x1A and 0x1B. The issue I'm having is that the values read from
them appear to be significantly different. I'm only able to get accurate
results off of the two 8 bit registers, which is frustrating because it is
slowing my performance by a decent chunk. Any ideas? Is there perhaps some
initialization that I have to do, I'm running it on top of a TS-7800 board.
Thanks for the help,
Mike
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|