[ts-7000] TS-7260 and COM2 at power up

["Rekcut_Nod" <>]

Hello, I have a 2-line vacuum fluorescent display connected to COM2 on my 
TS-7260 board.  It works fine in all ways, except for one oddity.  The display 
is programmed with a default message to display when it is powered on, until 
that message is overwritten by programs running on the TS-7260 using COM2.  I 
have noticed that when the TS-7260 is first powered on, a single funky 
character is written to the first character position of the display (often it 
appears as a x with a bar over it).  Has anyone else experienced this?  Is 
there any way to prevent it other than turning on the display a little later 
than the TS-7260?

Thank you,
Don



------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/