Will someone please post instructions for building the SD card from the image?
I assume that the image would need to be on a flash drive and that it would
need to be done on target?
Can it be done in Busybox or would you need to boot to a flash drive with
Linux? If so is there a complete instruction available?
I am using a TS-7553 but I assume that the procedure is pretty much the same
for all boards.
Note that the TS-75XX manual lists the following for jumpers:
Jumpers Mode1 Mode2 Boot mode
JP1 off, JP2 off 1 1 onboard flash, if flash uninitialized,
falls back to SD
JP1 on, JP2 off 1 0 MicroSD card
JP1 off, JP2 on 0 1 offboard (TS-752 or TS-9448) SPI flash
JP1 on, JP2 on 0 0 reserved
On the TS-7553 JP2 is used for CAN termination.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|