[ts-7000] TS-7800 RS-485 guidance?

["jtheath4u" <>]

Hi All,

First post to the group.  Also just getting started with Technologic Systems' 
TS-7800.  We're planning to use the board for motor controls.

One of the first tasks is to get RS-485 up and running.  Documentation is 
pretty sparse.  Need to clear bit 15 in the PC104/UART configuration register.  
Baud rate is set by 3 bits in uart-associated status register.

Do "normal" serial configuration operations work on the RS-485 port?  Does one 
open the device (say /dev/ttts2) and read/write as any other TTY?

Any guidance/instruction on 7800 RS-485 port use would be appreciated.

Thank you,   Joe



------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/