[ts-7000] 7260 SPI C Programming Example

["yavin229" <>]

Hi, I am trying to find some samples of code that exemplifies how to access the 
output of a device on the SPI bus. I have everything physically connected and 
as I understand it, I need to set one of the DIO channels (CS?) high to signal 
a conversion on my slave device. That part should be simple enough but the 
requirement to "Force the CS low to stop the conversion and apply a clock 
signal at SCK to read the results at SO" have me stumped. Not sure how to set 
apply a clock signal and read the results. If anyone is able to point me in the 
right direction I would greatly appreciate it! Thanks!





------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/