Re: [ts-7000] USB connection

[Ricardo Sifón <>]

Hi,

 

As I observe in the picture, you have an error:

There must be a space between part1 and /mnt /cf

mount -t vfat /dev/scsi/hos0/ bus0/target0/ lun0/part1   /mnt/cf

 

Ricardo

2010/7/8 Yuttanant Suwansiri <>

 

[Attachment(s) from Yuttanant Suwansiri included below]

Hi Ricardo,

   I tried that but still had no luck:(  (See the attached file)

Arm

--- On Wed, 7/7/10, Ricardo Sifón <> wrote:

From: Ricardo Sifón <>
Subject: Re: [ts-7000] USB connection
To: m("yahoogroups.com","ts-7000");" target="_blank">
Date: Wednesday, July 7, 2010, 7:03 PM

 

Hi,
 
You have to mount the pendrive. You can do this with the following command (1):

 

mount -t vfat /dev/scsi/hos0/ bus0/target0/ lun0/part1 /mnt/cf

 

Where "cf" is the folder where you will mount the pendrive.
As you create it before installing the pendrive.

 

mkdir /mnt/cf

Then you can access the pendrive contents of a folder like most of the system.

If you want to mount the flash drive every time you turn the board TS, you should add the line (1) in the file: rcS.sysinit located wihtin /etc/rc.d

 

Best Regards,

 

Ricardo Sifón

 

 

 

2010/7/6 ysuwansiri <m("yahoo.com","ysuwansiri");" target="_blank"> com>

 

Hi,

I have TS-7200.

I ran the command /usr/bin/loadUSBMod ules.sh, but couldn't get the USB connection to work.

How can I get the USB connection to work?

Thank you,

Arm

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___