Hi,
I'm trying to make a copy of the CF card for my TS7200 board but I ran into the
following errors:
fsck.ext2: Filesystem has unsupported feature(s) (/dev/hda1)
e2fsck: Get a newer version of e2fsck!
I put the CF into a card reader on a PC running Fedora 10, and made a copy of
the entire contents to the hard drive. I put in a new flash card and formatted
it to ext2 file system, and copied the files and folders to the new card. I
see that dd is preferred for this, but the cards are different size and I'm not
clear on how to create and restore the image for different partition sizes.
Just doing a straight copy, it complains about the filesystem. The complete
boot-up output is below. Any ideas?
Thanks,
Angelo
>> TS-BOOTROM, Rev 1.08 - built 10:44:37, May 26 2006
>> Copyright (C) 2006, Technologic Systems
>> TS-7200: Rev >E1 CPU, Rev C PLD, 32MB SDRAM, options ( RS485 )
+IDE failed to identify unit 0 - wrote: b0, read: 0
Ethernet eth0: MAC address 00:d0:69:40:66:ce
IP: 192.168.0.110/255.255.255.0, Gateway: 192.168.0.1
Default server: 192.168.0.1
RedBoot(tm) bootstrap and debug environment [ROMRAM]
Non-certified release, version current-TS_5 - built 11:24:54, Jun 7 2006
Platform: TS-7200 Board (ARM920T) Rev A
Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.
RAM: 0x00000000-0x02000000, [0x00044f88-0x01fdd000] available
FLASH: 0x60000000 - 0x60800000, 64 blocks of 0x00020000 bytes each.
== Executing boot script in 0.100 seconds - enter ^C to abort
RedBoot> fis load vmlinux
RedBoot> exec -c "console=ttyAM0,115200 root=/dev/hda1"
Using base address 0x00218000 and length 0x000c0000
Linux version 2.4.26-ts11 (gcc version 3.3.4) #215 Thu
Jun 8 14:30:17 MST 2006
CPU: Arm920Tid(wb) revision 0
Machine: ep9301
On node 0 totalpages: 2048
zone(0): 2048 pages.
zone(1): 0 pages.
zone(2): 0 pages.
On node 1 totalpages: 2048
zone(0): 2048 pages.
zone(1): 0 pages.
zone(2): 0 pages.
On node 4 totalpages: 2048
zone(0): 2048 pages.
zone(1): 0 pages.
zone(2): 0 pages.
On node 5 totalpages: 2048
zone(0): 2048 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: console=ttyAM0,115200 root=/dev/hda1
Console: colour dummy device 80x30
Calibrating delay loop... 99.94 BogoMIPS
Memory: 8MB 8MB 8MB 8MB = 32MB total
Memory: 28500KB available (1320K code, 350K data, 72K init)
Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
CPU: Testing write buffer: pass
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
devfs: v1.12c (20020818) Richard Gooch
devfs: boot_options: 0x1
JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc.
ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA
ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA
ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA
pty: 1024 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ enabled
rtc: no TS-5620 RTC detected.
ep93xx_eth() version: ep93xx_eth.c: V1.0 09/04/2003 Cirrus Logic
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
Technologic Systems TS-7XXX IDE initialization - driver version 1.3, 6/21/04.
hda: CF CARD 4GB, ATA DISK drive
ide0 at 0x8d000000-0x8d000007,0x88400006 on irq 32
hda: attached ide-disk driver.
hda: 7372512 sectors (3775 MB) w/1KiB Cache, CHS=7314/16/63
Partition check:
/dev/ide/host0/bus0/target0/lun0: [PTBL] [914/128/63] p1
TS-7200 flash: Found 1 x16 devices at 0x0 in 16-bit bank
Intel/Sharp Extended Query Table at 0x0031
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
Creating 3 MTD partitions on "TS-7200 flash":
0x00000000-0x00020000 : "TS-BOOTROM"
0x00020000-0x00620000 : "Linux"
0x00620000-0x00800000 : "RedBoot"
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 4096)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NetWinder Floating Point Emulator V0.97 (double precision)
VFS: Mounted root (ext2 filesystem).
Mounted devfs on /dev
Freeing init memory: 72K
INIT: version 2.84 booting
Creating extra device nodes...done.
Started device management daemon v1.3.25 for /dev
Checking root file system...
fsck 1.27 (8-Mar-2002)
e2fsck 1.27 (8-Mar-2002)
fsck.ext2: Filesystem has unsupported feature(s) (/dev/hda1)
e2fsck: Get a newer version of e2fsck!
fsck failed. Please repair manually and reboot. Please note
that the root file system is currently mounted read-only. To
remount it read-write:
# mount -n -o remount,rw /
CONTROL-D will exit from this shell and REBOOT the system.
Give root password for maintenance
(or type Control-D for normal startup):
(none):~#
(none):~# mount
/dev/hda1 on / type ext2 (rw)
proc on /proc type proc (rw)
none on /dev/pts type devpts (rw,gid=5,mode=620)
(none):~# umount /
(none):~# e2fsck -p -f -c -y /dev/hda1
e2fsck 1.27 (8-Mar-2002)
e2fsck: Filesystem has unsupported feature(s) (/dev/hda1)
e2fsck: Get a newer version of e2fsck!
(none):~#
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|