[ts-7000] DBus and TS -7390

[Edmondo Porcu <>]

Dear all,
I had succesfully used DBUS under kubuntu on my laptop to develop a qt application who handle the hotplug of a usb device.

When I cross-compile it and i bring it on my system-on-chip, I can't connect to the system bus.

I had actually installed hal and dbus, and the daemon correctly starts when I start the SOM. However,
when I try to connect:

dbusConn=new QDBusConnection(QDBusConnection::systemBus());
    qDebug(qPrintable("baseService of the bus" + dbusConn->baseService()));
    QStringList registeredServices = dbusConn->interface()->registeredServiceNames();
    for(int k=0;k<registeredServices.length();k++){
        qDebug(qPrintable(registeredServices.at(k)));
    }

I have a bus with no baseService and no registered service, which means I am not able to connect to the dbus. 
Do you have any clue?
Best Regards
Edmondo Porcu

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___