Re: [ts-7000] Re: Mechanical drawings for TS boards?

[Garrett Stritch <>]

I've not seen the 9700 board,  but it seems like you could get out a dial calipers and measure the spec, make adjustment to a mechanical drawing of one of the other boards. It sounds like you only need a few coordinates, i.e. the location of the PC104 header.

Harbor Freight has digital calipers on sale for $30!

On Mon, Sep 21, 2009 at 3:27 PM, Blair <> wrote:

 

--- In ts-7000%40yahoogroups.com, Garrett Stritch <> wrote:
>
> Try this:
> http://www.embeddedarm.com/documentation/ts-7300-mechanical.pdf
>

> On Sat, Sep 19, 2009 at 8:33 PM, Blair <> wrote:
>
> >
> >
> > Anyone know if there are mechanical drawings for the TS boards? Yes, PC/104
> > is a standard but I'm looking for the locations of headers and other
> > connections on a 9700 board and others.
> >
> >
> >
>

I found the mechanicals for every product it seems except the 9700 board. Bleah.

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___