|
I didn't set support for JFFS2. Isn't that more of a file system entry (I'm not a real linux expert by any means... more of a hack than anything)? The flash stuff that I was talking about was in this section # # Memory Technology Devices (MTD) for 2k NAND flash # CONFIG_MTD2K=y # CONFIG_MTD_DEBUG is not set CONFIG_MTD_PARTITIONS=y # CONFIG_MTD_CONCAT is not set # CONFIG_MTD_REDBOOT_PARTS is not set # CONFIG_MTD_CMDLINE_PARTS is not set # CONFIG_MTD_AFS_PARTS is not set CONFIG_MTD_CHAR=y CONFIG_MTD_BLOCK=y # CONFIG_FTL is not set # CONFIG_NFTL is not set # CONFIG_INFTL is not set Assuming the 7260 and 7250 use the same flash (which I couldn't tell you)... this was the missing step in getting the flash to work. But I think they do. The TS-7200 lists the flash as NOR flash, while the 7250 and 7260 list NAND flash. From what I understand, this is the actual driver that allows the kernel to read the flash... I'll send the complete .config file to your gmail account... note that it was for the 7250 rather than the 7260, but the two appear pretty close in terms of specs. wrote on 08/03/2009 01:59:24 PM: > With your procedures, I could compile the kernel correctly, but I > just can do it when I disable the support for CONFIG_JFFS2_FS_NAND. > But the system cannot boot correctly if I have this option disable in kernel. > > When I try to compile it with NAND support for JFFS2 enable, than I > get the following error: __._,_.___
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required) Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe __,_._,___ |