ts-7000
[Top] [All Lists]

[ts-7000] Re: Upgrading kernel version to 2.6 in TS-7250

To:
Subject: [ts-7000] Re: Upgrading kernel version to 2.6 in TS-7250
From: "j.chitte" <>
Date: Sun, 10 May 2009 16:36:33 -0000
--- In  "j.chitte" <> wrote:
>
> --- In  "j.montornes" <j.montornes@> wrote:
> >
> > Baiscally I've followed the steps described by Charlie in order to get 
> > 2.6.27.4 running using nfs filesystem. These are my steps:
> 
> I have a fresh 2.6.29.1 built and booting but it gets stuck in DHCP loop. 
> This is odd since I have configured all the interfaces as static as it was 
> for the 2.4 kernel.
> 
> 
> IP-Config: Retrying forever (NFS root)...                                     
>                          
> Sending DHCP requests ...... timed out!                                       
>                          
> IP-Config: Retrying forever (NFS root)...                                     
>                          
> PHY: 0:01 - Link is Down                                                      
>                          
> Sending DHCP requests .<6>PHY: 0:01 - Link is Up - 100/Full                   
>                          
> ..... timed out! 
> 
> /etc/sysconfig/ifcfg-eth0
> DEVICE=eth0
> IPADDR=192.168.1.50
> NETMASK=255.255.255.0
> NETWORK=192.168.1.0
> BROADCAST=192.168.1.255
> BOOTPROTO=static
> #BOOTPROTO=dhcp
> ENABLE=yes
> 
> 
> /etc/sysconfig/ifcfg-lo
> 
> DEVICE=lo
> IPADDR=127.0.0.1
> NETMASK=255.0.0.0
> NETWORK=127.0.0.0
> BROADCAST=127.255.255.255
> ENABLE=yes
> BOOTPROTO=static
> 
> /etc/sysconfig/network_cfg
> 
> ### Technologic Systems
> ### General Network Configuration File
> ###
>       NETWORKING=yes
>       GATEWAY=192.168.1.20
>       GW_DEV=eth0
> #     HOSTNAME="ts7200"
>       HOSTNAME="arm"
>       BOOTPROTO=static
>       DEFRAG_IPV4=no
>       FORWARD_IPV4=no
> 
> Is there some difference in the start up mechanism that I'm overlooking here?
> 
> TIA.
>
I should add I have  IP_PNP =[y] but why is this going into DHCP when I provide 
the ip to the kernel?

RedBoot> load -v -r -b 0x218000 -h 192.168.1.20 -m http /zImage-2.6.29
RedBoot> exec -c "console=ttyAM0,115200 ip=192.168.1.50 
nfsroot=192.168.1.20/mnt/nfs"

:?




------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

<Prev in Thread] Current Thread [Next in Thread>
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU