kenwmetzler wrote:
> I'm having trouble getting the UART on the COM2 connector to work in RS-
> 232 mode. I am only hooked up to pins 2, 3 and 5 to avoid any conflict
> with 485 signals. This setup works find on the COM1 connector when I
> reference it as /dev/ttyAM1. The dmesg command does show a ttyAM2 but
> this does not seem to work. I can open the device but sends & receives
> don't go anywhere. Do I need to load an additional driver and use a
> different name?
COM2 is an xuart. The module is xuart7350.
http://www.embeddedarm.com/about/resource.php?item=371#uart
Please note the important info regarding the uarts on this page.
> Thanks for your help,
> Ken
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16525 East Laser Drive
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|