--- In "mowengineer" <> wrote:
>
> Has anyone seen where the FPGA ETH1 ethernet port on the TS7300
> stops responding to ARP and or traffic?
This has been reported a few times on this list, but no real solution.
It seems to have an interrupt conflict with an external TS-SER4 card,
if you are using one:
http://tech.groups.yahoo.com/group/ts-7000/message/8380
Also it seems to slow down then stop all by itself as well. See the
thread at:
http://tech.groups.yahoo.com/group/ts-7000/message/7160
> Have the port setup with a static address and DHCP, eth1 and eth1:1.
>
> Have hot-plug and ifplugd setup for the ethernet ports.
>
> Can connect and use the connection then loss access. From a sniffer
> trace, I see the connected computer send an arp request to the TS7300
> looking for the MAC. No response.
> Have reset the ethernet ports on the connected computer to no avail.
> Symptom does not clear till the TS7300 is rebooted.
Reportedly you can unload & re-load the module to get it working again.
> Accessing the TS7300 from the console, there is no change in the ETH1
> config. Have tried starting and stopping the interface with no change.
>
> I have seen this occur on 3 separate TS7300 units.
>
> Have never lost network connectivity on ETH0 which leads me to suspect
> the FPGA hardware??
Probably. If you can reproduce this (sounds like you can), I'd
contact TS via email. (Remember this ML has no official TS
participation).
Regards, ........ Charlie
> Any ideas would be appreciated.
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|