Has anyone seen where the FPGA ETH1 ethernet port on the TS7300 stops
responding to ARP and or traffic?
Have the port setup with a static address and DHCP, eth1 and eth1:1.
Have hot-plug and ifplugd setup for the ethernet ports.
Can connect and use the connection then loss access. From a sniffer
trace, I see the connected computer send an arp request to the TS7300
looking for the MAC. No response.
Have reset the ethernet ports on the connected computer to no avail.
Symptom does not clear till the TS7300 is rebooted.
Accessing the TS7300 from the console, there is no change in the ETH1
config. Have tried starting and stopping the interface with no change.
I have seen this occur on 3 separate TS7300 units.
Have never lost network connectivity on ETH0 which leads me to suspect
the FPGA hardware??
Any ideas would be appreciated.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|