--- In <> wrote:
>
> Hi
>
> I need a board with support for at least 6 serial ports (8 serial
ports if possible) and 2 ethernet ports. Has anyone in the list
experience in using a board with this configuration? The TS-7370 seems
to fit our purpose since it has the option of mapping serial ports on
the PC104 connector, but I still don't have a clear answer from
embeddedarm.com if this configuration is already available, and I need
to have this boards in a short time frame with . Any suggestions?
>
> Thanks in advance!
>
> Best regards
>
> Fernando
>
I have a project where I selected the TS7300 because I had the same
require of two Eth interfaces on two networks.
I have worked with virtual ETH and VLANs but wanted phy separation.
It was cheaper than buying a single Eth board with a added Eth module
The TS7300 also has 8-10 serial ports dependent on configuration
needed or if control leads are needed.
I setup a serial port for separate devices dependent on what we hook
up to monitor. Port 1 - Equip 1, Port 2 - Equip 2, etc.
This makes it easier for field techs to install.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|