> Hello,
>
> I have 2 TS-7250 SBC and for each I have a TS-RF2 ZigBee Module. As I
> am quite now in this can somebody give me instructions how to simply
> connect this two SBC over ZigBee and how to test the connection.
There are two kernel modules you will need to make sure are loaded:
tsuart0.o and tsuart-rf.o (in that order). After both modules are loaded
you can check what device node was created by running 'dmesg'. It should
say something like like /dev/ttyTS1 or something like that. That is the
device you will use; it looks just like a serial port. A simple test might
be to run a simple terminal program and try typing on both sides to see if
you receive on the other side.
> Thank you all
>
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|