[ts-7000] tsbat3 with ts7300

["Charlie Wallace" <>]

i just got my ts-bat3 installed, having some problems with it.

firstly

:charlie# insmod ./tsuart-bat3.o
./tsuart-bat3.o: init_module: Operation not permitted
Hint: insmod errors can be caused by incorrect module parameters, including 
invalid IO or IRQ 
parameters.
      You may find more information in syslog or the output from dmesg

if i run it again

:charlie# insmod ./tsuart-bat3.o
:charlie# lsmod
Module                  Size  Used by    Tainted: GF
tsuart-bat3             1152   0  (unused)
lincan                 53098   0  (unused)
tkusb                  10776   0  (unused)
af_packet               9456   0  (unused)
zd                    264068   0  (unused)
hci_usb                 8144   1
bluez                  30428   3  [hci_usb]
open_eth                4448   0  (unused)
sdcard1                 9848   0  (unused)
tsuart-73               1364   0  (unused)
tsuart0                 8728   0  [tsuart-bat3 tsuart-73]
keybdev                 1772   0  (unused)
hid                    13520   0  (unused)
input                   3320   0  [keybdev hid]
usb-ohci-ep93xx          632   0  (unused)
usb-ohci               15360   0  [usb-ohci-ep93xx]
usbcore                55728   2  [tkusb zd hci_usb hid usb-ohci]
pcipool                 1888   1  [usb-ohci-ep93xx usb-ohci]
ts7300fb                3496  63
fbcon-cfb16             3528   0  [ts7300fb]
fbgen                   2944   0  [ts7300fb]

so it seems to have loaded the second time ?

but if run

./bat3 --charge 400

from the shell.


it'll lockup the system, i'm guessing i might have  irq problems  ?

hmm acutally i just tried ./bat3 --help and it froze solid too, might be an 
issue with the 
executable i downloaded from ftp://ftp.embeddedarm.com/bat3/bat3
i'll try compiling it up... the docs do say options are handled oddly, but 
--help should be valid.


Also its a shame but with two stacked cards the enclosure no longer fits, its 
about 3-4 mm off, its 
probably possible to lower the standoffs by that much and squeeze it in, or i 
could maybe remove the 
top pass through connector.




 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/