[ts-7000] 7800 booting from onload flash

To:
Subject:	[ts-7000] 7800 booting from onload flash
From:	"JD" <>
Date:	Wed, 02 Jan 2008 15:11:41 -0000

When I power on the 7800, I get the "Booting from onboard NAND
flash..." message and then it sits there forever.

If I boot from sd card, the board boots up, and i can run mtdmount and
mount and see the linux partition on the mtdblock3.

Is there anyway of seeing where it is hanging, or anything I can try
to get it back up and running from flash?



 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

<Prev in Thread]	Current Thread	[Next in Thread>
[ts-7000] 7800 booting from onload flash, JD <=

Previous by Date:	[ts-7000] Re: cannot exec cc1 message, edaudio2000
Next by Date:	[ts-7000] Re: cannot exec cc1 message, Andy Mercier
Previous by Thread:	[ts-7000] Re: Cannot boot 1GB flash, Rob
Next by Thread:	[ts-7000] Re: Serial port example for TS7800, JD
Indexes:	[Date] [Thread] [Top] [All Lists]

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU