Re: [ts-7000] Using TS-9420

["Gary Wicker" <>]

Aha!  That was the issue.  Thanks for the assistance...

On 10/31/07, <m("oilgear.com","sjanisch");">> wrote:

It worked for me.

The only trouble I had was missing part of the documentation where it said the PC-104 holes should line up...

What this meant is that the TS-9420 board had most of the real estate over the side of the TS-7xxx board.  In other words it is not over

In other words...


             |-------- <- TS-9420
-------------|-        <- TS-7xxx
                                   ^
                 PC/104 pins

wrote on 10/31/2007 10:21:19 AM:

> Has anyone used the TS-9420 to recover a bricked TS-7250?  I ordered
> one of these but it came with no documentation.  I searched the
> group and followed the only directions I found, but my board does
> nothing when powered up with a TS-9420 -- no serial output at all.

>  
> I've set the jumpers on the 9420 as follows:
>  
> 1: on     (boot from 9420)
> 2: on     (ARM mode)
> 3: on     (write en. flash)
> 4: off     ???
> 5: off     ???
>  
> Do you have to change any jumpers on the TS-7250 when booting from
> this board?  Is there a howto or a readme file anywhere?  It would
> be nice not to have to send this board back for re-flashing.  Thanks!
>  
> Gary

>

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___