You can use the SerialBlaster software to recover a bricked TS-7250 with a
serial connection.
-Curtis.
On October 31, 2007 11:21 am, Gary Wicker wrote:
> Has anyone used the TS-9420 to recover a bricked TS-7250? I ordered one of
> these but it came with no documentation. I searched the group and followed
> the only directions I found, but my board does nothing when powered up with
> a TS-9420 -- no serial output at all.
>
> I've set the jumpers on the 9420 as follows:
>
> 1: on (boot from 9420)
> 2: on (ARM mode)
> 3: on (write en. flash)
> 4: off ???
> 5: off ???
>
> Do you have to change any jumpers on the TS-7250 when booting from this
> board? Is there a howto or a readme file anywhere? It would be nice not to
> have to send this board back for re-flashing. Thanks!
>
> Gary
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|