Re: [ts-7000] ADC on the 7300

[David Hawkins <>]

Yan Seiner wrote:
> I have a question on the manual for the TS7300.
> 
> On page 37 in the "DIO1 Header Pin Configuration" table, it shows ADC4
> connected to pin 8.  But on page 38, it says:
> 
> On the TS-7300, the DIO Port pins 4 and 6 are connected to two of the
> EP9302 12-bit A/D converter inputs (ADC0 and ADC4, respectively).
> 
> Which is it?
> 

When in doubt, check the schematic :)

p5 shows ADC4 connected to pin 8 on DIO1.
p1 shows that ADC4 is pin 131 on the processor.

So the first comment is correct, the second is not.

Dave



 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/