Hi,
I have just started using above combination of boards.
Problem is that /dev/tts/ has only 2 entries, 4 and 5. What happened
to 6 and 7?
lsmod gives:
Module Size Used by Tainted: P
tsuart-bat3 1132 0 (unused)
tsuart7260 1628 0 (unused)
tsuart0 8880 0 [tsuart-bat3 tsuart7260]
vfat 10140 0 (unused)
fat 29608 0 [vfat]
uname -a:
Linux ts7200 2.4.26-ts11 #3 Tue Jun 6 14:13:14 MST 2006 armv4l unknown
At the boot time, I get:
>> TS-BOOTROM, Rev 1.08 - built 10:40:29, Jun 12 2006
>> Copyright (C) 2006, Technologic Systems
>> TS-7260: Rev >E1 CPU, Rev F PLD, 64MB SDRAM
>> TS-5620: detected, battery OK, time ( 09:43:37, Aug 24 2007 )
>> Off-board serial at: COM5 COM6 COM7 COM8
....
ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA
ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA
ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA
pty: 1024 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ enabled
ttyS04 at 0x89c003a8 (irq = 40) is a 16550A
ttyS05 at 0x89c002a8 (irq = 33) is a 16550A
....
$ setserial /dev/tts/4
/dev/tts/4, UART: 16550A, Port: 0x89c003a8, IRQ: 40
$ setserial /dev/tts/5
/dev/tts/5, UART: 16550A, Port: 0x89c002a8, IRQ: 33
$ cat /proc/interrupts
4: 5917 timer
32: 0 tsuart_uarts
39: 0 EP9312_Eth
52: 120 amba
54: 314 amba
Err: 0
Same happens if I do not load tsuart-bat3
If I make node 6, mknod 6 c 4 70 , still cannot access device.
What am I doing wrong?
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|