ts-7000
[Top] [All Lists]

[ts-7000] Re: SPI, A/D docs

To:
Subject: [ts-7000] Re: SPI, A/D docs
From: "Yan Seiner" <>
Date: Fri, 27 Jul 2007 18:19:14 -0000
--- In  "charliem_1216" <> wrote:
>
> Hi Yan --
> 
> The on-board EP9302 A/D is documented in the user guide Frank 
> mentioned, Ch 20 IIRC.  But according to the TS-7300 manual, only 
> one of the 5 channels is brought out to the DIO header (or two, 
> depending on which page of the manual you are on).  The TS-7300 
> manual, the EP9301 manual, and the EP9302 datasheet should have the 
> info you need for using the onboard A/D.

Thanks.  I forgot about the ep9301 manual; the ep9302 manual is pretty
skimpy.  We're getting one of the A/D channels run out to a mux on our
daughterboard, which will make life simpler (as soon as I figure out
how to read a muxed A/D signal.)

Anyone know how you go about reading a muxed signal?  I know in
principle how a mux works but I've never tried to read one.

> 
> If you mean the 4-channel A/d that comes on the TS-732 daughter 
> board, then sorry, I have no idea. 
> 
> I haven't looked at the logger file you mentioned.  Is it talking to 
> an A/D over SPI?

It's talking to the temp sensor over SPI.  Turns out that the on-board
temp sensor for the ts7300 is an SPI device, which is really cool for
us - since we can measure the temp on board as well remotely with the
same chip.  :-)

--Yan

> 
> Regards, ......... Charlie
> 
> --- In  "Frank Pagliughi" <fpagliughi@> 
> wrote:
> >
> > Not sure about the A/D, but I believe the SPI is on the processor, 
> and
> > is documented in the EP9301 manual (which also applies to the 
> EP9302):
> > 
> > You can download it from the Cirrus site:
> > 
> > www.cirrus.com/en/pubs/manual/EP9301_User_Guide.pdf
> > 
> > 
> > Frank
> > 
> > --- In  "Yan Seiner" <yan@> wrote:
> > >
> > > Does anyone have a pointer to the docs for the SPI bus and the 
> EP9302
> > > A/D for the TS7300?
> > > 
> > > I'm looking for a programming manual...
> > > 
> > > I'm trying to decipher the NetTempLogger.c in the files 
> section -
> > > where does one get the address and port info?
> > > 
> > > Thanks,
> > > 
> > > --Yan
> > >
> >
>




 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 

<Prev in Thread] Current Thread [Next in Thread>
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU