Hello,
> Can any one plz guide me which address should I use in order to
> communicate with PC/104 bus for 8-bit I/O cycles..
>
> From the manual I can see the Physical Address Region for 8 bit I/O cycle
> is 0x11E00000 thru 0x11E003FF but while I m trying to write to this location
> I get this...
>
> "Unable to handle kernel paging request at virtual address 81e00000"
>
> In my earlier attempt to write the HPI driver over PC/104 bus, I could
> write to the location by memory mapping the device.. but in my recent pgm I
> am not getting hold on that..
>
> If any one can share Kernel Mode driver for PC/104 bus would be great
> help..
In linux24/include/asm-arm/arch-ep93xx/regmap.h there are some helpful
#defines. You can use TS7XXX_IO8_BASE...
//Eddie
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|