Hi everyone!
I have a TS7250 with a homebuilt temp-sensor for the serial port. My
problem is that I am unable to boot the TS-7250 while the temp-sensor is
connected. If I connect the sensor and try to boot the board, the boot
process will halt somewhere and not continue until I disconnect the
sensor. After the boot is finished i can connect the sensor and
everything will be working fine, regardless of what I did with the
com-port during the boot.
I have removed JP2 to disable the redboot console and I have edited
inittab to disble getty on com-1 but it still doesn'r work. When the
boot process has hung it is possible to ping the board but not connect
to it via ssh. (I'm using NFS-boot)
What else can i try?
Regards Per Öberg
--
Per Öberg, Ph.D. Student
Address: Division of Vehicular Systems
Department of Electrical Engineering
Linköpings universitet
581 83 Linköping, SWEDEN
Phone: +46 (0)13-28 23 69
e-mail:
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|