Re: [ts-7000] Accessing DIO2 in 7300

To:
Subject:	Re: [ts-7000] Accessing DIO2 in 7300
From:	"Alvaro Aguirre" <>
Date:	Mon, 20 Nov 2006 19:05:44 -0300

I haven't use the DIO2 port, but check http://www.embeddedarm.com/Manuals/ts-7300-manual-rev1.2.pdf
Just write the correct registers and you are done. About the 5 Volt's how much current you will need from it?

On 11/20/06, mekala_new <> wrote:

Hi,
I am new to this group. I have used DIO1 in 7300 as a general IO
header to connect keypad and other devices.Could we use DIO2 as a
general IO pin too? I would like to connect a relay in DIO2. Also I
need a +5v input for relay but DIO2 has only +3.3v. Any suggestions
are welcome..

Thanks,
Mekala

__._,_.___

SPONSORED LINKS

`Single board computer`	`Hardware`	`Computer running slow`
`Linux os`	`Single board`

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___

<Prev in Thread]	Current Thread	[Next in Thread>
[ts-7000] Accessing DIO2 in 7300, mekala_new Re: [ts-7000] Accessing DIO2 in 7300, Alvaro Aguirre <=

Previous by Date:	Re: [ts-7000] Zigbee, Don W. Carr
Next by Date:	[ts-7000] Re: Using PPP?, naturalwatt
Previous by Thread:	[ts-7000] Accessing DIO2 in 7300, mekala_new
Next by Thread:	[ts-7000] Zigbee, Yan Seiner
Indexes:	[Date] [Thread] [Top] [All Lists]

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU