| To: | |
|---|---|
| Subject: | [ts-7000] New Project |
| From: | "Art" <> |
| Date: | Wed, 05 Apr 2006 22:57:58 -0000 |
I have the TS-7200 board for developing some lighting control software.
It will have a web interface for configuring the device. It will also
control light levels with DMX protocal. I have a driver I programed on
an atmel AVR. I'm not sure about how to connect the board with this
chip using the SPI line of communcation. I'm not sure of the FRAME pin
in the spi communcation. I also note that the voltage is three volt on
the board and the driver has a five volt. I may then go with a CAN
interface if the SPI doesn't work.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: [ts-7000] TS-7250 filesystem access before and after chroot, jimfred |
|---|---|
| Next by Date: | RE: [ts-7000] TS-7250 filesystem access before and after chroot, Jim Jackson |
| Previous by Thread: | [ts-7000] TS-7250 filesystem access before and after chroot, jimfred |
| Next by Thread: | [ts-7000] Re: [tsd -7000] New Project, Christopher Friedt |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU