[ts-7000] IDE Failure??

To:
Subject:	[ts-7000] IDE Failure??
From:	David Huffman <>
Date:	Wed, 29 Mar 2006 23:47:22 -0800 (PST)

OK, next problem...I noticed that when my system
begins to boot, the first non-comment line reads:

+IDE failed to identify unit 0 - wrote: b0, read: 0

If I remove the flash card and reboot again, the
failure goes away and I get:

+No devices on IDE controller 0

Has anybody seen this "IDE failure" message before??
Any ideas as to what's going wrong here??

Thanks,
-Dave




 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

<Prev in Thread]	Current Thread	[Next in Thread>
[ts-7000] IDE Failure??, David Huffman <=

Previous by Date:	Re: [ts-7000] Re: Keyboard Problem., David Huffman
Next by Date:	Re: [ts-7000] Initial permissions for ramfs, Jim Jackson
Previous by Thread:	[ts-7000] Initial permissions for ramfs, Tom Hansen
Indexes:	[Date] [Thread] [Top] [All Lists]

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU