[ts-7000] Com2 trouble

To:
Subject:	[ts-7000] Com2 trouble
From:	"kosmic85" <>
Date:	Thu, 09 Mar 2006 17:50:51 -0000

Hi, 

I'm using a ts-7250 board to communicate with a wireless modem on the
com2 port. The modem work perfectly for 1 hour or 2 and after that he
hang and reset. But when I use the com1 (db9 connector) or a computer,
everything work great.

The modem only use the TX, RX and GND line. 

Its like there some kind of noise on the com2 of the ts-7250. I'm not
too sure.

did someone has this kind of trouble ?

Thank you

Etienne







 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/

<Prev in Thread]	Current Thread	[Next in Thread>
[ts-7000] Com2 trouble, kosmic85 <=

Previous by Date:	Re: [ts-7000] Occassional boot problem..., Lennert Buytenhek
Next by Date:	[ts-7000] IRQ driven GPIO, Yan Seiner
Previous by Thread:	[ts-7000] Re: compiling a kernel, slweasel2002
Next by Thread:	[ts-7000] IRQ driven GPIO, Yan Seiner
Indexes:	[Date] [Thread] [Top] [All Lists]

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU