--- In "Yan Seiner" <> wrote:
>
> --- In Jim Jackson <> wrote:
> >
> >
> >
> >
> > On Thu, 1 Dec 2005, Yan Seiner wrote:
> >
> > > The greater issue is that I need 5V TTL logic so I need a memory map
> > > for the K7V video board with the registers laid out....
> > >
> >
> > Why? What's wrong with just a couple of resistors or zener and
resistor?
> > Jim
> >
>
> Well, because the IR sensor I need runs off of 5V; if I can get 5V TTL
> then it's just a matter of hooking it up... Otherwise, I will need
> more components to provide 5V. I'm thinking one pin to power it, one
> pin to sense it. Simple....
>
> OTOH, if one of the hardware folks has any suggestions for connecting
> a Vishay TSOP 1738 or similar to the 3.3V GPIO on the tx7xx0 boards
> I'd love to hear them....
>
> --Yan
>
Yan,
It looks like the Vishay part is a remote control receiver/
demodulator. All you need to do to "condition" the signal is to use a
resistive divider. The part can handle an output current up to 5ma. So
if power consumption is not an issue, use a 1.8k and a 3.3k resistor
(1ma). Keep it simple. If power consumption is an issue, scale the
resistors up (18k/33k, 180k/330k, etc) Keep the ratio constant. The
resistive divider will limit the output voltage range into an area the
micro can handle.
----------------OUT
1.8k | 3.3k
IN>---/\/\/\/\/--o--/\/\/\/\/----GND
NJOY,
Jamey
------------------------ Yahoo! Groups Sponsor --------------------~-->
Get Bzzzy! (real tools to help you find a job). Welcome to the Sweet Life.
http://us.click.yahoo.com/KIlPFB/vlQLAA/TtwFAA/CFFolB/TM
--------------------------------------------------------------------~->
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|