Hello
After a power failure, when I boot my TS-7250 without Ethernet cable
connected red and green LEDs remain in solid state. In the console I
get TS-NANDBOOT and TS-BOOTROM and stays there.
If I boot the SBC with Ethernet cabled connected, green LED remains
solid and red blinking slowly. The board reboot every 5 seconds or so.
It gets to TS-NANDBOOT and TS-BOOTROM and then reboots.
I ran serial_blaster program but when I get to redboot prompt and
connect the Ethernet cable, it reboots.
Does anyone know what is the problem? Maybe with redboot or something
like that?
I've checked the documentation and haven't seen information about what
the LEDs mean in solid state, both of them.
Thank You,
Fabian Alfaro
------------------------ Yahoo! Groups Sponsor --------------------~-->
Fair play? Video games influencing politics. Click and talk back!
http://us.click.yahoo.com/2jUsvC/tzNLAA/TtwFAA/CFFolB/TM
--------------------------------------------------------------------~->
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|