Those error messages may be from the "phantom" third USB port,
either that, or you have a flaky USB device on the bus. All these
Cirrus Logic CPU's use the same silicon, and they made a model with
3 USB ports. The Ep9302, however, only has 2 bonded out on the CPU
packaging. Nonetheless, the Linux kernel USB OHCI driver still
detects the third non-existent USB port and sometimes complains
about it not behaving. (which it won't, since its not connected)
//Jesse Off
--- In "nitelitephoto" <> wrote:
> I have a TS-7250 and use loadUSB{Modules,}.sh to enter the
> debian256-5-6-2005.tar.bz2 image. I am concerned by two error
> messages below:
> 1. usb_control/bulk_msg: timeout
> 2. cannot get config descriptor 0, Connection timed out (110)
>
> I also noticed the first error message when I was having problems
with
> my USB webcam (which isn't working), though the USB disk generally
works.
>
> Here is the context:
>
> $ loadUSB.sh
> Creating extra device nodes...done.
> Started device management daemon v1.3.25 for /dev
> Checking root file system...
> fsck 1.27 (8-Mar-2002)
> e2fsck 1.27 (8-Mar-2002)
> /dev/sda1: clean, 20513/74592 files, 265646/297568 blocks
> Calculating module dependencies... depmod: *** Unresolved symbols
in
> /lib/modules/2.4.26-vrs1-cirruodepmod: *** Unresolved symbols in
> /lib/modules/2.4.26-vrs1-cirrus-1-2-1-
ts8/kernel/drivers/usb/catcodepmod:
> *** Unresolved symbols in
> /lib/modules/2.4.26-vrs1-cirrus-1-2-1-
ts8/kernel/drivers/usb/usbnodepmod:
> *** Unresolved symbols in
> /lib/modules/2.4.26-vrs1-cirrus-1-2-1-
ts8/kernel/fs/cramfs/cramfsodone.
> Loading modules: usb-ohci-ep93xx fat vfat
> Checking all file systems...
> fsck 1.27 (8-Mar-2002)
> none on /dev/pts type devpts (rw,gid=5,mode=620)
> Starting hotplug subsystem: usb.
> Running 0dns-down to make sure resolv.conf is ok...done.
> Cleaning: /etc/network/ifstate.
> Setting up IP spoofing protection: rp_filter.
> Configuring network interfaces: done.
> Starting portmap daemon: portmap.
> Running ntpdate to synchronize clock.
> Recovering nvi editor sessions... done.
> Starting system log daemon: syslogd.
> Starting hotplug subsystem: usbusb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> [...repeated dozens of times...]
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> cannot get config descriptor 0, Connection timed out (110)
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> usb_control/bulk_msg: timeout
> [..repeated a few more times...]
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|