Greetings,
"mount -t jffs2 /dev/mtd0 /mnt/flash" killed my board :( It began to
erase block, hit ctrl+c, but too late. I can't boot anymore now.
So i enabled JP1, and setted minicom to 9600 8N1 (no hardware control
flow) :
- '<' caracters are displayed continuously
- red led is blinking, green led is lit (even with no DB9 cable wired)
This continuous loop of '<' is suspicious. I tried to send "CRUS" + 2048
bytes. Nothing happend. The EP9301ref manual says that a '>' should
appear. I hope that nothing is damaged.
Is a logical way, a '<' should be displayed and then wait for "CRUS" +
2048 bytes and then display '>'.
Does Cirrus provide some stuff for recovering and empty flash ?
What about the test/factory jumper, can I use it to health-check my board ?
Help is hardly welcome.
Matthieu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|