| To: | Gilles GIGAN <> |
|---|---|
| Subject: | Re: [pwc] VIDIOCPWCMPTRESET |
| From: | "David N. Lombard" <> |
| Date: | Thu, 12 Jun 2008 20:36:49 -0700 |
Gilles GIGAN wrote: > Hi all, > In the intialisation section of my application, I reset the pan & tilt > of a Logitech QuickCam Sphere (046d:08b5) using > ioctl(VIDIOCPWCMPTRESET). Sometimes during the reset, the webcam stays > stuck after panning to one of its exteme position (the tilt doesnt and > comes back to the center). Hmmm, I've never seen that. I wonder if it's a version thing, as my unit is now several years old... In any event, I added pan/tilt to camstream 0.26.3. I use the VIDIOCPWCMPTRESET in a "reset-to-(0,0)" function to ensure the position in case of manual adjust while powered off. Just used this control about 30 times with consistent results. -- David N. Lombard _______________________________________________ pwc mailing list http://lists.saillard.org/mailman/listinfo/pwc |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [pwc] VIDIOCPWCMPTRESET, Gilles GIGAN |
|---|---|
| Next by Date: | [pwc] Vendor support in pwc development, Emmanuel Kasper |
| Previous by Thread: | [pwc] VIDIOCPWCMPTRESET, Gilles GIGAN |
| Next by Thread: | [pwc] Vendor support in pwc development, Emmanuel Kasper |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU