This is the dmesg output after I load the pwc module and plug in the camera:
usbcore: deregistering driver Philips webcam
pwc Philips webcam module removed.
pwc: Philips webcam module version 10.0.11-unofficial loaded.
pwc: Supports Philips PCA645/646, PCVC675/680/690,
PCVC720[40]/730/740/750 & PCVC830/840.
pwc: Also supports the Askey VC010, various Logitech Quickcams, Samsung
MPC-C10 and MPC-C30,
pwc: the Creative WebCam 5 & Pro Ex, SOTEC Afina Eye and Visionite
VCS-UC300 and VCS-UM100.
usbcore: registered new driver Philips webcam
usb 3-1: new full speed USB device using uhci_hcd and address 11
Is that the same you see when you plug yours?
Indy500 wrote:
Hi,
I bought a SPC900NC today an the driver 10.0.11 works fine. The Cam was
detected properly without any problem.
But I can't set the resolution to 640x480. I set the compression to 3 but it
still shows 320x240. And I saw that it is an USB 1.1 device. On every Shop
they write USB 2.0 device but it is USB 1.1, it loads ohci/uhci not ehci.
Beside that, pan/tilt doesn't work, all other options works well so far I
tested it.
_______________________________________________
pwc mailing list
http://lists.saillard.org/mailman/listinfo/pwc
_______________________________________________
pwc mailing list
http://lists.saillard.org/mailman/listinfo/pwc
|