pwc
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[pwc] SPC900NC

from [Indy500] [Permanent Link][Original]
To:
Subject: [pwc] SPC900NC
From: Indy500 <>
Date: Wed, 1 Mar 2006 23:38:11 +0100 
Hi,

I bought a SPC900NC today an the driver 10.0.11 works fine. The Cam was 
detected properly without any problem.

But I can't set the resolution to 640x480. I set the compression to 3 but it 
still shows 320x240. And I saw that it is an USB 1.1 device. On every Shop 
they write USB 2.0 device but it is USB 1.1, it loads ohci/uhci not ehci.

Beside that, pan/tilt doesn't work, all other options works well so far I 
tested it.
_______________________________________________
pwc mailing list

http://lists.saillard.org/mailman/listinfo/pwc
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  [pwc] SPC900NC, daniele
Next by Date:  Re: [pwc] SPC900NC, daniele
Previous by Thread:  [pwc] SPC900NC, daniele
Next by Thread:  Re: [pwc] SPC900NC, daniele
Indexes:  [Date] [Thread] [Top] [All Lists]
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU