WRONG!! SoRRY!!
This is it!
One resistor goes from + of the batteries to pin 3 of the XLR and the
other from + of the battery to pin 2.
Then the same arrangement to the other channel.
Klas.
At 19:12 2008-06-06, you wrote:
>Klas Strandberg wrote:
>
> > It's easy Curt - connect 4 or five 9v batteries in series. Connect
> > minus to ground.
> > Then connect two 6,8k resistors per channel from the +pole of the
> > battery to pin 2 and 3 of the XLR's.
> >
> > The resistors need to be 2% matched if you are going to connect a
> > dynamic microphone or a microphone with an output transformer. If the
> > resistors differ, like one is + 5% and the other -5%, then current
> > will go through the coil / transformer winding and - worst case -
> > cause damage.
>
>Thank you Klas,
>
>Just to clarify...
>
>Do you mean 6.8k resistors? (You put a comma in there.)
>
>And are the two resistors per channel series or parallel?
>
>Curt
>
>
>------------------------------------
>
>"While a picture is worth a thousand words, a
>sound is worth a thousand pictures." R. Murray Schafer via Bernie Krause
>Yahoo! Groups Links
>
>
>
Telinga Microphones, Botarbo,
S-748 96 Tobo, Sweden.
Phone & fax int + 295 310 01
email:
website: www.telinga.com
|