[Top] [All Lists]

Re: soldering station?

Subject: Re: soldering station?
From: "G W" gwapuffin
Date: Fri Dec 21, 2007 7:38 am ((PST))
Everything you may want to know about the Weller WLC100
Gerald White Muscatine, IA

----- Original Message ----
From: Greg Weddig <>
Sent: Thursday, December 20, 2007 2:46:51 PM
Subject: [Nature Recordists] Re: soldering station?

I have soldered a lot of cable over the years, now that it's not part
of my job I enjoy it again. I have most always used a Weller WLC100.
They are widely available. Be sure to get a few tools to help you do
the job:

Look at the available tips and determine which one is the most useful,
I tend to use the skinny screwdriver tip shaped one for XLR connectors.
Solder sucker, for removing extra solder
Hemostats, for holding cable and connectors
a little Panavice can also be used for holding connectors. Or use a
vicegrip lightly clamped to the connector with electrical tape to
protect the finish.
A few colors of heat shrink in different sizes, you will want to be
sure to put a small piece over the shield wire.
A little tin of tip cleaner is alway useful.

A good pair of safety glasses, that don't slide off you nose when you
are leaning over small work.
If possible soldier outdoors, any soldier, lead, silver tin or
otherwise is not meant to be inhaled or injested. If you are
soldering indoors get fitted for a respirator or use a exhaust system.
Be sure to wash your hands after soldering.

Watch your heat, too cold and you'll be frustrated, too hot and you'll
be melting the wire insulation. PRACTICE, it takes a while to get the
hang of it.

And finally, don't forget to put the boot on the wire, BEFORE you
solder it.

--greg weddig
Baltimore, MD
http://gregweddig. net

--- In naturerecordists@ yahoogroups. com, "David Kuhn"
<dkuhn012001@ ...> wrote:
> Greetings and Happy Holidays from Hawai`i!
> Armed with a reel of Canare Starquad and a batch of Neutrik 
> connectors, I'm finally delving into making up
> my own cables. The cheap soldering tool I have is hampering my
> progress. Can someone recommend an adequate soldering station? I 
> don't expect to do anything more complex
> than cables.
> Thanks,
> David
> >>>>>>>>>>>> >>>>>>>>> >>>>>>>> 
> David Kuhn 
> www.SoundsHawaiian. com
> Kaua'i, Hawaii 
> dkuhn012001@ ... 
> 808 335 0398 
> Mail to: PO Box 1018 
> Waimea, HI 96796 
> <<<<<<<<<<<< <<<<<<<<< <<<<<<<<

Looking for last minute shopping deals?  
Find them fast with Yahoo! Search.

<Prev in Thread] Current Thread [Next in Thread>

The University of NSW School of Computer and Engineering takes no responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the naturerecordists mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU