On 1/31/2013 5:44 AM, khouryelie wrote:
> HELLO,
>
> I AM WORKING WITH A ts-7200, and running my com2 port in full duplex
>
> I AM NOT ABLE TO RECEIVE DATA ON MY COM2 PORT, I CAN ONLY TRANSMIT
>
> WHY IS THAT ?
>
> _______________________________
>
> FROM TS-7200 MANUAL
>
> switch COM2 into Full duplex RS-485 mode, the COM2 Mode register at
> 0x22C0_0000
> must be set to Hex 01. In this mode, the TX drivers are always asserted.
>
>
> "TX drivers are always asserted" is this my prob ?
Please answer my question from the other thread you posted about this.
It sounds like you have it wired up for RS485 half-duplex and trying to
run in full-duplex.
--
Jason Stahls
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|