Re: [ts-7000] TS-SER4 Crystal Oscillator

[Mark Featherston <>]

Ron,

Actually it does just require an oscillator.  This would be an example of a compatible form factor:
http://search.digikey.com/us/en/products/ECS-2100AX-073.7/X961-ND/827258

Once there is a signal on those pins, the TS-SER4 will use that for the clock instead of the 1.8432MHz from the PC104 bus.  I updated the wiki with this and a few more details:
http://www.embeddedarm.com/wiki/index.php/TS-SER4#X1_and_Non-standard_Baud_Rates

Best Regards, 
________________________________________________________________
 Mark Featherston, Technologic Systems | voice: (480) 837-5200
 16525 East Laser Drive                | fax: (480) 837-5300
 Fountain Hills, AZ 85268              | web: www.embeddedARM.com 

On 12/19/2011 01:36 PM, ronmuzzi wrote:

 

Has anyone installed a crystal oscillator on the TS-SER4 board? It can provide higher baud rates. There is no description in the documentation as to what component to use. There are 4 pins on the trace, so it requires more than just a crystal!

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___