Technical service said me that I can use the D3-D7 PC104 pins, but I think that
these interrups (IRQ10-14) don't provoke an kernel interrup. Moreover, there
are not information about how to control the IRQ in the FPGA.
We have found 3 general porpuse pins in the microcontroller (MPP3,6,7) that are
routed to the FPGA. I think probably these pins are our solution, but I don't
know where are routed after the FPGA or which registers I need to configure.
Anyone has used an external interrupt with the TS-7800 board?
Best regards,
--- In "jblesa" <> wrote:
>
> Hello,
>
> I need to control an external interrupt in the TS-7800 board and I need an
> accessible pin to control it. I mean, I'm going to connect a signal and I
> want to create an interruption with an edge.
>
> I've saw that MV88F5182 has several interrupts, but I haven't found any
> accessible pin that correspond with the interrupts.
>
> Please, can anyone tell which interrupt can I control and which is the pin in
> the board?
>
> Thanks,
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|