On Wed, 22 Sep 2010, ysuwansiri wrote:
> Guys,
>
> I'm a newbie and I have a problem booting linux
> debian-sarge-256MB-05-01-2006. I used kernel vmlinux-7200-ts11.bin.
So it did an fsck to check the file system - that much is ok.
All the stuff you quote is normal stuff and doesn't help.
You don't say what happenned after the reboot. If that failed, then
please post the failed boot.
I would put the CFdisk into a USB adapter connected to a linux development
system (you do have one, right?). Make sure the CFdisk is unmounted and run
fsck on card. Then try and boot from the card in ts7200.
>
>
> How can I fix this?
>
>
> Here is the error message:
>
>
>
> >> TS-BOOTROM, Rev 1.08 - built 10:44:37, May 26 2006
> >> Copyright (C) 2006, Technologic Systems
> >> TS-7200: Rev >E1 CPU, Rev C PLD, 32MB SDRAM, options ( MAX197-ADC RS485 )
>
> +IDE failed to identify unit 0 - wrote: b0, read: 0
> Ethernet eth0: MAC address 00:d0:69:40:76:4b
> IP: 192.168.0.50/255.255.255.0, Gateway: 192.168.0.1
> Default server: 192.168.0.1
>
> RedBoot(tm) bootstrap and debug environment [ROMRAM]
> Non-certified release, version current-TS_5 - built 11:53:02, Jun 7 2006
>
> Platform: TS-7200 Board (ARM920T) Rev A
> Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.
>
> RAM: 0x00000000-0x02000000, [0x00044f88-0x01fdd000] available
> FLASH: 0x60000000 - 0x61000000, 128 blocks of 0x00020000 bytes each.
> == Executing boot script in 0.100 seconds - enter ^C to abort
> ^C
> RedBoot> load -r -b 0x218000 -m disk hda1:/vmlinux-7200-ts11.bin
> Raw file loaded 0x00218000-0x00395da7, assumed entry at 0x00218000
> RedBoot> exec -c "console=ttyAM0,115200 root=/dev/hda1"
> Using base address 0x00218000 and length 0x H����Linux version
> 2.4.26-ts11 (gcc version 3.3.4) #1 Mon Nov 17
> 16:26:02 MST 2008
> CPU: Arm920Tid(wb) revision 0
> Machine: ep9301
> On node 0 totalpages: 2048
> zone(0): 2048 pages.
> zone(1): 0 pages.
> zone(2): 0 pages.
> On node 1 totalpages: 2048
> zone(0): 2048 pages.
> zone(1): 0 pages.
> zone(2): 0 pages.
> On node 4 totalpages: 2048
> zone(0): 2048 pages.
> zone(1): 0 pages.
> zone(2): 0 pages.
> On node 5 totalpages: 2048
> zone(0): 2048 pages.
> zone(1): 0 pages.
> zone(2): 0 pages.
> Kernel command line: console=ttyAM0,115200 root=/dev/hda1
> Console: colour dummy device 80x30
> Calibrating delay loop... 99.94 BogoMIPS
> Memory: 8MB 8MB 8MB 8MB = 32MB total
> Memory: 28500KB available (1320K code, 350K data, 72K init)
> Dentry cache hash table entries: 4096 (order: 3, 32768 bytes)
> Inode cache hash table entries: 2048 (order: 2, 16384 bytes)
> Mount cache hash table entries: 512 (order: 0, 4096 bytes)
> Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)
> Page-cache hash table entries: 8192 (order: 3, 32768 bytes)
> CPU: Testing write buffer: pass
> POSIX conformance testing by UNIFIX
> Linux NET4.0 for Linux 2.4
> Based upon Swansea University Computer Society NET3.039
> Initializing RT netlink socket
> Starting kswapd
> devfs: v1.12c (20020818) Richard Gooch
> devfs: boot_options: 0x1
> JFFS2 version 2.2. (C) 2001-2003 Red Hat, Inc.
> ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA
> ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA
> ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA
> pty: 1024 Unix98 ptys configured
> Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ enabled
> rtc: no TS-5620 RTC detected.
> ep93xx_eth() version: ep93xx_eth.c: V1.0 09/04/2003 Cirrus Logic
> Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
> ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
> Technologic Systems TS-7XXX IDE initialization - driver version 1.3, 6/21/04.
> hda: TOSHIBA THNCF256MQG, CFA DISK drive
> ide0 at 0x8d000000-0x8d000007,0x88400006 on irq 32
> hda: attached ide-disk driver.
> hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: task_no_data_intr: error=0x04 { DriveStatusError }
> hda: 500736 sectors (256 MB) w/2KiB Cache, CHS=978/16/32
> Partition check:
> /dev/ide/host0/bus0/target0/lun0: p1
> TS-7200 flash: Found 1 x16 devices at 0x0 in 16-bit bank
> Intel/Sharp Extended Query Table at 0x0031
> Using buffer write method
> cfi_cmdset_0001: Erase suspend on write enabled
> Creating 3 MTD partitions on "TS-7200 flash":
> 0x00000000-0x00020000 : "TS-BOOTROM"
> 0x00020000-0x00e20000 : "Linux"
> 0x00e20000-0x01000000 : "RedBoot"
> NET4: Linux TCP/IP 1.0 for NET4.0
> IP Protocols: ICMP, UDP, TCP, IGMP
> IP: routing cache hash table of 512 buckets, 4Kbytes
> TCP: Hash tables configured (established 2048 bind 4096)
> NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
> NetWinder Floating Point Emulator V0.97 (double precision)
> /dev/ide/host0/bus0/target0/lun0: p1
> /dev/ide/host0/bus0/target0/lun0: p1
> VFS: Mounted root (ext2 filesystem).
> Mounted devfs on /dev
> Freeing init memory: 72K
> INIT: version 2.86 booting
> Creating extra device nodes...done.
> Started device management daemon v1.3.25 for /dev
> /dev/ide/host0/bus0/target0/lun0: p1
> modprobe: Can't open dependencies file /lib/modules/2.4.26-ts11/modules.dep
> (No such file or directory)
> Checking root file system...
> fsck 1.37 (21-Mar-2005)
> e2fsck 1.37 (21-Mar-2005)
> /dev/hda1 has gone 49710 days without being checked, check forced.
> Pass 1: Checking inodes, blocks, and sizes
> Pass 2: Checking directory structure
> Pass 3: Checking directory connectivity
> Pass 3A: Optimizing directories
> Pass 4: Checking reference counts
> Pass 5: Checking group summary information
>
> /dev/hda1: ***** FILE SYSTEM WAS MODIFIED *****
> /dev/hda1: ***** REBOOT LINUX *****
> /dev/hda1: 14822/62744 files (0.6% non-contiguous), 228956/250352 blocks
>
> fsck corrected errors on the root partition, but requested that
> the system be rebooted (exit code 3).
>
> Automatic reboot in 5 seconds.
>
> flushing ide devices: hda
> Restarting system.
>
>
> Thank you,
>
> Arm
>
>
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|