Hi
I have a 7260 that doesn't boot and had been setup to boot from SD.
So I found the image
ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7200-linux/binaries/ts-images/sdimage-new.dd.bz2
put that on an SD via "dd" and the board boots.
I setup the cross compiler with cygwin. Have my binary compiled, however, the
board doesn't have LSZ or LRZ!! Does anyone know what image does?
(Or even know what the differences are with the images they have on their site?
)
On the same note - is there better documentation anywhere that describes how to
get the other images to work in much more detail? The instruction manual for
from TS I followed to a "t" and they don't work (manual describes how to put
debian-sarge-1.15.tar on SD). You end up with one partition on the SD card and
during booting it halts looking for other partitions. The above sdimage-new
worked I think simply because the dd setup all the partitions.
Wouldn't mind being able to restore the flash image on the board so it could
boot from linux from flash. Not sure what image on their website to use though?
Not sure if there are issues putting on image to this NAND flash board etc.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|