I am trying to do something similar. Did you ever figure out a solution to
your problem?
--- In "ambro915" <> wrote:
>
> I am trying to capture video from my Lego cam with the TS-7800. I am
> using TS's 2.6.21 kernel with the default config. I have built the
> qc-usb driver and it loaded fine. However capturing video doesn't
> work. When I try to capture video, the activity led on the cam turns
> on, off and again on and stays that way during the 'capture'. However
> no frames are captured. The command "cat /dev/video0" outputs garbage
> on my PC, but nothing on the board. Dmesg says:
>
> Linux video capture interface: v2.00
> usbcore: registered new interface driver quickcam
> usb 2-1: new full speed USB device using mv5182_ehci and address 2
> usb 2-1: configuration #1 chosen from 1 choice
> quickcam: QuickCam USB camera found (driver version QuickCam USB 0.6.6
> $Date: 2006/11/04 08:38:14 $)
> quickcam: Kernel:2.6.21-ts bus:2 class:FF subclass:FF vendor:046D
> product:0850
> quickcam: Sensor VV6410 detected
> quickcam: Registered device: /dev/video0
>
> and there are no errors. The driver works on the TS-7400 with the same
> 2.6 kernel.
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|